For water-damage restoration and restorative drying work, the Dri-Eaz F211 DriForce InterAir Drying System delivers high-pressure air to remove moisture trapped in structural cavities. To speed up drying time, use the Dri-Eaz DriForce Wall Drying System to simultaneously dry different target areas, including ceilings, dry walls, behind or under cabinets, and headers. This compact and lightweight drying system provides every accessory to restore even the most difficult-to-access areas. This drying system is designed with high-pressure air technology and uses less than 3 amps of 115-volt power.
Please Note: This DriForce System is not designed to extract water or debris. Proper use of this system is for the movement of air only.
Complete System Includes
- DriForce Air Mover
- 13 7-foot hoses with cuffs
- 8 manifolds
- 1 400-foot coil of PVC tubing
- 100 ¼-in. injector nozzles
- 4 manifold end caps
- 5 coupler fittings
- 2 T-fittings
- 25 tube extender connectors
- 1 muffler
- 2 wheeled duffel bags
Drying Speed Efficiency
With the Dri-Eaz DriForce InterAir Drying System, you can deliver a high-quality restoration service to your customers by returning structures to pre-loss conditions in less time, saving the property owner the cost of reconstruction. For maximum drying efficiency, the Dri-Eaz F211 DriForce InterAir Drying System employs four drying mechanisms:
Injection Mode: Pushes dry air into structural cavities
Extraction Mode: Pulls moist air out of structural cavities
Dehumidification: When extra-dry air is required for drying difficult areas, position the output airflow from a dehumidifier near the DriForce air inlet
Heat: The blow motor generates heat, which increases the temperature of the air that enters the airflow for increased drying efficiency
Other system components designed for drying efficiency include:
Air Nozzle Fins: To form a tight seal between the air nozzle and drilled hole, the fins lock in place. This is useful for drying ceilings.
High Coverage: Treat over 90 feet of 2 x 4-constructed wall at one time.
High-Pressure Air: Delivers up to 38 inches of static pressure while using less than 3 amps of 115-volt power.
Versatility for Every Restoration Project
Together with the Injection/Extraction drying modes, the Dri-Eaz DriForce Wall Drying System contains every accessory to dry difficult-to-access areas as well as challenging materials, including lath and plaster, double-sheeted or fire walls, insulated walls, and walls covered with vinyl wallpaper or impermeable paint. To speed up drying time, the DriForce is designed to dry a combination of structures at the same time, including walls, cabinets, headers, and ceilings.
Minimal Damage: The DriForce air nozzles need installation holes that are less than ¼”, cutting back on time required to patch and repair holes.
Durable Construction: Built for years of service for even the most difficult of restoration jobs, the DriForce is built with durable, long-lasting materials, including a stainless steel-based and double-wall polyethylene housing.
The Dri-Eaz DriForce InterAir Drying System dries wet walls, ceilings, cabinets, and headers without damage.
What Customers Love
2 Drying Methods - Force air in or vacuum air out. This system offers 2 effective drying methods.
Low Power - The system averages just 3 amps in use.
Things To Consider
Compatible with Rescue Mat System - Use with the Dri-Eaz Rescue Mat Panel System fast drying of hardwood floors.