Hi-E Dry Vehere Pool & Spa Dehumidifier

Keep your indoor pool area free of chemical odors, foggy windows, structural moisture problems, mold and mildew, and general uncomfortable high-humidity levels using the Hi-E Dry Vehere Pool and Spa Dehumidifier. Delivering an airflow rate up to 540 cubic feet per minute (CFM), this versatile dehumidifier incorporates FOCUS™ technology to achieve high-efficiency water removal at lower operating costs. The Hi-E Dry Vehere dehumidifier also features a stainless steel, corrosion-resistant body, standard MERV-11 filters, easy-to-use manual controls, multiple drainage options, and more.

Superior Moisture Removal

Featuring the highest dehumidification capacity in its class, the Hi-E Dry Vehere effortlessly removes up to 192 pints of excessive moisture each day. Vehere’s difference is an innovative heat transfer technology called FOCUS ™.

FOCUS technology works by using refrigeration to cool an incoming air stream below its dewpoint while it passes through an evaporator coil, which causes moisture removal. The cool, dry air is not only dispersed throughout your environment, it is also used to pre-cool the incoming air stream. This results in a dramatic 200 percent increase in overall efficiency, and two to three times more water removal per kilowatt-hour of electricity than standard dehumidifiers.

High-Efficiency, Low Cost

The Hi-E Dry Vehere was created to offer users a low-cost, high-capacity water removal system. FOCUS technology allows engineers to create a high-performance dehumidifier with a smaller refrigeration system. The result is a lower purchase cost to dealers and end users.

The Vehere’s compact refrigeration system also requires a smaller electric load. The system draws just 12 amps of electricity. As a result, this industrial-size dehumidifier can be plugged into any standard electrical outlet, yielding lower energy costs and lower annual operating costs. This Hi-E Dry dehumidifier also uses the eco-friendly R-410A refrigerant, which will not deplete ozone and is safer for the environment.

Flexible Drainage Options

Thanks to gravity drainage and ducting options, your Vehere can be installed in a variety of locations to meet your needs. This Hi-E Dry dehumidifier comes with a 4-foot drainage hose that can be located near a floor drain or other suitable outlet for removing unwanted condensate.

Your Vehere dehumidifier also comes with ducting components that allow you to safely place your dehumidifier in a separate location and still receive its moisture removal benefits. The Vehere duct kit comes with a 12-inch flanged duct collar for the intake opening and a tabbed duct collar for the exhaust outlet.

Simple, Straightforward Design

The workhorse design of this Hi-E Dry dehumidifier is exceptionally easy to use. Located on the side of the Vehere’s corrosion-resistant stainless steel cabinet is the power switch to start or end operation. The included humidistat can be easily attached to the body of the Vehere or attached to a wall. When the unit is not located in the actual humid area, Vehere engineers recommend attaching the humidistat to a wall in the area that needs moisture removal to achieve accurate humidity readings.  Once the humidistat is in place, set it to the desired humidity level and enjoy the drier, more comfortable air produced.

Additionally, this industrial Hi-E Dry dehumidifier features easy-roll casters to make moving a cinch. To protect the life of your Vehere dehumidifier and produce exceptionally clean air by capturing harmful airborne contaminants, two easy-to-remove MERV-11 filters are also included.